| 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 <2023> 2024 2025 | Index | 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 <2023> 2024 2025 |
| <== Date ==> | <== Thread ==> |
|---|
| Subject: | Re: Problems using Universal I/O |
| From: | Jukka Pietarinen via Tech-talk <tech-talk at aps.anl.gov> |
| To: | dipirro <giampiero.dipirro at lnf.infn.it>, tech-talk at aps.anl.gov |
| Date: | Thu, 26 Jan 2023 09:06:17 +0200 |
Hi Giampiero,From the hardware point of view on the mTCA-EVR-300U the front panel Universal I/Os are configured/mapped through registers at offset 0x440-0x447 (Front Panel Universal I/O Mapping Registers) and the RTM Universal I/Os are mapped through registers at offset 0x480-0x493 (Transition Board Output Mapping Registers).
Unfortunately, I cannot help with configuring this through mrfioc2. Thanks, Jukka On 1/25/23 4:53 PM, dipirro via Tech-talk wrote:
Hi, I have an mrf system set up as follows:One mTCA-EVR-300 with 2 Universal I/O LVTTL Output UNIV-TTL and one mTCA.4 Rear Transition Module (mTCA-EVRTM-300) with 3 Universal I/O LVTTL Output UNIVI installed mrfioc2 but I don't know how to configure it to allow the use of Universal I/O