Hi Kevin,
I figured I could try to remove the SPC_NOMOD from the dbd (and a
bo/calcout record to write to it), but it feels too hackish. What I was
really trying to figure out is if there was a field I could put a link
in to set the limit switch fields (similar to RDBL/DINP/etc).
*Pedro Nariyoshi*
Software Controls Engineer
Facility for Rare Isotope Beams
Michigan State University
640 South Shaw Lane
East Lansing, MI 48824, USA
Tel. 517-908-7352
Email: nariyosh at frib.msu.edu <mailto:nariyosh at frib.msu.edu>
1633986722804
------------------------------------------------------------------------
*From:* Kevin Peterson <kmpeters at anl.gov>
*Sent:* Tuesday, November 28, 2023 10:18:13 AM
*To:* Nariyoshi, Pedro; tech-talk at aps.anl.gov
*Subject:* Re: Simulated limit switches on motorSim motor
[EXTERNAL] This email originated from outside of FRIB
Pedro,
The HLS/LLS/RHLS/RLLS fields are read-only.
Kevin
On 11/21/23 12:24, Nariyoshi, Pedro via Tech-talk wrote:
Hi,
I am working on creating virtual motors to control some slits. One
problem I have is that I couldn't find a way to set the
HLS/LLS/RHLS/RLLS fields. Is there a way to control these (whether
having an input link to these values or a writing them directly with a
calcout or bo record)?
Thank you very much
*Pedro Nariyoshi*
Software Controls Engineer
Facility for Rare Isotope Beams
Michigan State University
640 South Shaw Lane
East Lansing, MI 48824, USA
Tel. 517-908-7352
Email: nariyosh at frib.msu.edu <mailto:nariyosh at frib.msu.edu <mailto:nariyosh at frib.msu.edu>>
1633986722804