Re: Simulated limit switches on motorSim motor

["Nariyoshi, Pedro via Tech-talk" <tech-talk at aps.anl.gov>]

Hi Kevin,

I figured I could try to remove the SPC_NOMOD from the dbd (and a bo/calcout record to write to it), but it feels too hackish. What I was really trying to figure out is if there was a field I could put a link in to set the limit switch fields (similar to RDBL/DINP/etc). 

Pedro Nariyoshi Software Controls Engineer Facility for Rare Isotope Beams Michigan State University 640 South Shaw Lane East Lansing, MI 48824, USA Tel. 517-908-7352 Email: nariyosh at frib.msu.edu

---

From: Kevin Peterson <kmpeters at anl.gov>
Sent: Tuesday, November 28, 2023 10:18:13 AM
To: Nariyoshi, Pedro; tech-talk at aps.anl.gov
Subject: Re: Simulated limit switches on motorSim motor

 

[EXTERNAL] This email originated from outside of FRIB
Pedro,

The HLS/LLS/RHLS/RLLS fields are read-only.

Kevin

On 11/21/23 12:24, Nariyoshi, Pedro via Tech-talk wrote:
> Hi,
>
>
> I am working on creating virtual motors to control some slits. One
> problem I have is that I couldn't find a way to set the
> HLS/LLS/RHLS/RLLS fields. Is there a way to control these (whether
> having an input link to these values or a writing them directly with a
> calcout or bo record)?
>
>
> Thank you very much
>
>
> *Pedro Nariyoshi*
>
> Software Controls Engineer
>
> Facility for Rare Isotope Beams
>
> Michigan State University
>
> 640 South Shaw Lane
>
> East Lansing, MI 48824, USA
>
> Tel. 517-908-7352
>
> Email: nariyosh at frib.msu.edu <mailto:nariyosh at frib.msu.edu>
>
>       
>
> 1633986722804
>
>