EPICS Home

Experimental Physics and Industrial Control System


 
1994  1995  1996  1997  1998  <19992000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  Index 1994  1995  1996  1997  1998  <19992000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019 
<== Date ==> <== Thread ==>

Subject: StripTool-2-4-b6
From: Ron Chestnut <rpc@SLAC.Stanford.EDU>
Date: Wed, 12 May 1999 12:08:51 -0700 (PDT)
If the engineering units for a PV are blank, the configuration is saved with a blank token 
for the UNITS associated with a curve. Loading such a file fails with no error messages. I 
have taken to deleting the offending line so that life continues in the control room.

I can see how to quickly just ignore on input OR not output the Units line; is there a 
newer version of StripTool available? Has this problem been seen and addressed elsewhere?

Thanks in advance.

/Ron Chestnut


Navigate by Date:
Prev: Re: LeCroy 1440 HV support Randy MacLeod
Next: Re: StripTool-2-4-b6 Christopher Larrieu
Index: 1994  1995  1996  1997  1998  <19992000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019 
Navigate by Thread:
Prev: Joining the EPICS Tech-Talk Maria Tzamtzi
Next: Re: StripTool-2-4-b6 Christopher Larrieu
Index: 1994  1995  1996  1997  1998  <19992000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019