EPICS channel access errors

Experimental Physics and Industrial Control System

1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 <2004> 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024	Index	1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 <2004> 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024
<== Date ==>		<== Thread ==>

Subject:	channel access errors
From:	Geoff Savage <[email protected]>
To:	EPICS Tech-Talk <[email protected]>
Date:	Mon, 06 Dec 2004 14:44:09 -0600

Hi,

We have just finished upgrading about 75% of the control system nodes to EPICS 3.14.6/vxworks 5.5. The remaining nodes are running EPICS 3.13.4 with some patches/vxworks 5.3.1. We have noticed more channel access errors with the later version of epics in the system than with an all EPICS 3.13.4 system. Is this to be expected at this time? Will the EPICS 3.14.7 release remove the errors? I understand that I don't have any details but the situatuions encountered are not reporduceable and everyone can get their work done. Over the past week while we have installed the new software we have been fielding questions about error messages appearing that have not been seen before.

Geoff

Replies:: Re: channel access errors Robert Soliday; RE: channel access errors Jeff Hill

Navigate by Date:: Prev: Re: Labview Shared Memory Interface Paul Sichta; Next: Re: channel access errors Robert Soliday; Index: 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 <2004> 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024
Navigate by Thread:: Prev: RE: Labview Shared Memory Interface Liyu, Andrei; Next: Re: channel access errors Robert Soliday; Index: 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 <2004> 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024