EPICS Home

Experimental Physics and Industrial Control System


 
1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  <2005>  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024  2025  Index 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  <2005>  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024  2025 
<== Date ==> <== Thread ==>
Subject: Re: PCI CAMAC Highway Driver?
From: Noboru Yamamoto <[email protected]>
To: Paul Sichta <[email protected]>
Cc: [email protected]
Date: Wed, 09 Mar 2005 13:59:53 +0900
Hi,

Paul Sichta wrote:
We are currently driving CAMAC serial highways using the Hytec VSD-2992 VME module on a vxWorks IOC, with Rivers/Tang/Bjorkland rec/dev/drv software. I'd like to replace that with a PCI highway driver on a Linux or RTEMS IOC. Has anyone also done this?

This is may not what you wants. But in KEK we evaluated and are using a network attached
Camac Crate controller. It iclude CPU and Linux is running on it. So that you can directly
connect it to EPICS based control system. Only part of ISONE APIs are supported currently.

Regards,

Noboru
KEK, JAPAN

References:
PCI CAMAC Highway Driver? Paul Sichta
Navigate by Date:
Prev: RE: about Tektronix TDS3000 series oscilloscopesdevice device support liushu
Next: Re: dbpf before iocInit... Ralph Lange
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  <2005>  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024  2025 
Navigate by Thread:
Prev: PCI CAMAC Highway Driver? Paul Sichta
Next: RE: PCI CAMAC Highway Driver? Graham S Cross
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  <2005>  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024  2025