Re: CAMAC-based stepper motor controllers

[Brad Cumbia <cumbia@jlab.org>]

Have you checked out the M540 Stepper motor controller from Highland 
technologies.  That is what we use at JLAB.  With Vxworks and EPICS.
Hope this helps

Brad Cumbia
Accelerator Network Administrator/Senior Controls Technologist
Thomas Jefferson National Accelerator Facility
Electrical Engineering Support Group
Instrumentation & Control Systems
Accelerator Computing Environment
12000 Jefferson Avenue
Newport News, Virginia 23606
Phone (757)269-5839
Pager (757)584-5839
Fax (757)269-7309
      ____ __  ___
     / / //  \/ _ \
  __/ / // - / _  /
 /___/___/._/_.__/
=================================================
()
------------------------------------------------
||* * * * * * * * * * OOOOOOOOOOOOOOOOOOOOOOOOO|
||* * * * * * * * * * :::::::::::::::::::::::::|
||* * * * * * * * * * OOOOOOOOOOOOOOOOOOOOOOOOO|
||* * * * * * * * * * :::::::::::::::::::::::::|
||* * * * * * * * * * OOOOOOOOOOOOOOOOOOOOOOOOO|
||:::::::::::::::::::::::::::::::::::::::::::::|
||OOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOO|
||:::::::::::::::::::::::::::::::::::::::::::::|
||OOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOO|
||:::::::::::::::::::::::::::::::::::::::::::::|
||OOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOO|
||:::::::::::::::::::::::::::::::::::::::::::::|
||OOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOO|
||----------------------------------------------
||
||
||
||



Darrell Nineham wrote:
> Yes there is, Hytec produce 2404 
>
> It is in use at Brookhaven. They have been using them for a few years; I
> don't know if they have EPICS support (anyone out there in tech-talk
> land know the answer ?). The E500 has not been produced for some years
> and our 2404 was adopted at BNL to replace exactly that unit.
>
> Darrell Nineham
> Hytec Electronics Ltd.
> Tel: +44 (0) 118 975 7770
> Fax: +44 (0) 118 975 7566
> Web: www.hytec-electronics.co.uk
>  
> ++++++++++++++++++++++++++++++++++++++++++++
> This email and any files transmitted with it are confidential and
> intended solely for the use of the individual or entity to whom they are
> addressed. If you have received this email in error, please notify the
> sender immediately. The views expressed in the message are those of the
> individual author and may not necessarily represent the views of Hytec
> Electronics Ltd.
>
>
> -----Original Message-----
> From: Peregrine M. McGehee [mailto:peregrine@lanl.gov] 
> Sent: 21 November 2005 16:18
> To: tech-talk@aps.anl.gov
> Subject: CAMAC-based stepper motor controllers
>
>
> I am looking for multi-channel CAMAC-based stepper motor controllers
> that have EPICS device support available and are still being
> manufactured. Anything out there besides the DSP E500?
>
> Best regards,
>      Peregrine