EPICS VMIC 2534 3.14 support?

Experimental Physics and Industrial Control System

1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 <2007> 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 2025	Index	1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 <2007> 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 2025
<== Date ==>		<== Thread ==>

Subject:	VMIC 2534 3.14 support?
From:	"Laznovsky, Michael" <[email protected]>
To:	<[email protected]>
Date:	Wed, 31 Oct 2007 12:37:57 -0700

Hi- does anyone out there have EPICS 3.14 support for the VMIC 2534 module?  The EPICS 
website shows only a 3.13 version.

Found 3.14 support for VMIC 3122/4132 here: http://www.fel.duke.edu/epics/downloads/ 
(but haven't tried them yet).

thanks,
Mike

Replies:: Re: VMIC 2534 3.14 support? Dale L. Brewe; Re: VMIC 2534 3.14 support? Steven Hartman

References:: Is there any chance that I can change SCAN parameter dynamically? Zhichu Chen; Re: Is there any chance that I can change SCAN parameter dynamically? Ned Arnold; Re: Is there any chance that I can change SCAN parameter dynamically? Maren Purves

Navigate by Date:: Prev: Re: Is there any chance that I can change SCAN parameter dynamically? Maren Purves; Next: Re: VMIC 2534 3.14 support? Dale L. Brewe; Index: 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 <2007> 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 2025
Navigate by Thread:: Prev: Re: Is there any chance that I can change SCAN parameter dynamically? Maren Purves; Next: Re: VMIC 2534 3.14 support? Dale L. Brewe; Index: 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 <2007> 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 2025