EPICS Re: About Runnig of epics

Experimental Physics and Industrial Control System

1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 <2008> 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 2025	Index	1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 <2008> 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 2025
<== Date ==>		<== Thread ==>

Subject:	Re: About Runnig of epics
From:	Dirk Zimoch <[email protected]>
To:	Selim Ünal <[email protected]>
Cc:	[email protected]
Date:	Tue, 09 Sep 2008 10:46:51 +0200

Hi Selim,

It's me again. Maybe I mixed up the setup.sh with the startup/Site.profile from base. From which package is that setup.sh file? Apparently not from base-3.14.9. Anyway, I still think it the EPICS_HOST_ARCH variable that it missing. Try to set it to linux-x86.

Dirk

Selim Ünal wrote:

I installed the epics in system of linux(debian) with command of ./setup.sh .Then , I write " startIoc.sh " or "startMedm.sh" , I dont start epics. Could you help me? It give error that is "Virtual Linac doesn't support this architecture:Linux unknown"


--
Dr. Dirk Zimoch
Paul Scherrer Institut, WBGB/006
5232 Villigen PSI, Switzerland
Phone +41 56 310 5182

References:: About Runnig of epics Selim Ünal

Navigate by Date:: Prev: Re: About Runnig of epics Dirk Zimoch; Next: RE:- Epics Developer Chris Joseph; Index: 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 <2008> 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 2025
Navigate by Thread:: Prev: Re: About Runnig of epics Dirk Zimoch; Next: EPICS base and/or EDM with debugging info Carl Schumann; Index: 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 <2008> 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 2025