Error from Autosave version 4-4

["Ernest L. Williams Jr." <ernesto@slac.stanford.edu>]

Hi,

I am getting the following error from autosave version 4-4:
==========================================================
create_monitor_set("motor_positions.req", 5, "P=U01:, M=CM1:motor")
0x00000000 (0)
   create_monitor_set("motor_settings.req", 30, "P=U01:, M=CM1:motor")
0x00000000 (0)
  
   create_monitor_set("motor_positions.req", 5, "P=U01:, M=CM2:motor")
save_restore:create_data_set: 'motor_positions.req' already in c 
mode0xffffffff (-1)
   create_monitor_set("motor_settings.req", 30, "P=U01:, M=CM2:motor")
save_restore:create_data_set: 'motor_settings.req' already in c 
mode0xffffffff (-1)
  
   create_monitor_set("motor_positions.req", 5, "P=U01:, M=CM3:motor")
save_restore:create_data_set: 'motor_positions.req' already in c 
mode0xffffffff (-1)
   create_monitor_set("motor_settings.req", 30, "P=U01:, M=CM3:motor")
save_restore:create_data_set: 'motor_settings.req' already in c 
mode0xffffffff (-1)
================================================================

I guess this means that it is not reentrant like the sequencer?

In any case, we will do the request file like this:
========= motor_positions.req =================
$(P):CM1:motor.DVAL
$(P):CM1:motor.OFF
$(P):CM2:motor.DVAL
$(P):CM2:motor.OFF
$(P):CM3:motor.DVAL
$(P):CM3:motor.OFF
==========================================


Thanks,
Ernest