Ron,
Isn't there a problem with an older version of the maxV not finding boards on reboot sometimes?
Mark
________________________________
From: [email protected] on behalf of Xu, Huijuan
Sent: Mon 3/23/2009 1:53 PM
To: Ron Sluiter
Cc: EPICS
Subject: RE: Motor problems(RBV can't update itself)
Hello,
It gets more weird today.
I get "controller is not running. motor_init_record_com(): card does not
exit!" errors. The LED on IOvMAX board is green.
With dbior, I get the following:
Oms MAXv motor card #0 @ 0x9FFFF000, id:
I tried reboot and still the same.
Regards,
Huijuan
-----Original Message-----
From: Ron Sluiter [mailto:[email protected]]
Sent: Monday, March 23, 2009 10:09 AM
To: Xu, Huijuan
Cc: EPICS
Subject: Re: Motor problems(RBV can't update itself)
Hello Huijuan,
Is this a stepper or DC motor?
Since you mention the ERES field, I'm guessing this is a DC
motor. What is the value of the MIP field when the motor
is stuck in the Moving state?
Ron
Xu, Huijuan wrote:
Hello,
I'm using OMS MAXv motion controller. The motor record version is 6.3.
The motor worked well several days ago with this version but goes
weird when I use it today.
RBV field can't update automatically. I have to reset the MRES or ERES
field and just the two fields to update RBV.
MOVN kept 1 all the time after motor began its first moving. DMOV does
not reset to 1 after position is reached.
Many thanks.
Regards,
Huijuan