Re: RTEMS-MVME2300

[Janet Anderson <jba@aps.anl.gov>]

Your readline library may need ncurses. 
Try commenting out the "COMMANDLINE_LIBRARY=READLINE" line 
and uncommenting the "COMMANDLINE_LIBRARY=READLINE_NCURSES" line 
in base/configure/CONFIG_SITE.Common.linux-x86.

Janet


----- Original Message -----
From: "Qazi Zia-ul-Haque" <smzhaq@gmail.com>
To: "Eric Norum" <eric@norum.ca>, "Till Straumann" <strauman@slac.stanford.edu>
Cc: tech-talk@aps.anl.gov
Sent: Wednesday, January 11, 2012 9:58:27 PM
Subject: Re: RTEMS-MVME2300

Hello 

I have come to the step of installing EPICS for rtems-mvme2307. However the make is going unsuccessful. 

I am attaching the output of running make. I need guidance to proceed. 

Regards 
Zia 


On Wed, Jan 4, 2012 at 11:53 AM, Eric Norum < eric@norum.ca > wrote: 


The difference is that -DMY_DO_BOOTP=rtems_bsdnet_do_bootp tells the BSP to get the board network configuration from a BOOTP/DHCP server while -DMY_DO_BOOTP=NULL tells the BSP to get the network configuration from the NVRAM. 



On Jan 3, 2012, at 7:46 PM, Michael Davidsaver wrote: 

> Hello Qazi, 
> 
> There is support in RTEMS for the mvme2307 which is used with epics at 
> NSLS.  The epics build config used (see attached) is very similar to 
> that of the mvme2100. 
> 
> The only real difference that I can see from the 2100 config is 
> 
>> #ARCH_DEP_CFLAGS += -DMY_DO_BOOTP=NULL 
>> ARCH_DEP_CFLAGS += -DMY_DO_BOOTP=rtems_bsdnet_do_bootp 
> 
> I don't know what necessitated this though. 
> 
> I hope that this is helpful. 
> 
> Michael 
> 

-- 
Eric Norum 
eric@norum.ca