1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 <2012> 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 | Index | 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 <2012> 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 |
<== Date ==> | <== Thread ==> |
---|
Subject: | Re: Re: Problems in using VX2 motor controller |
From: | "sunjl" <[email protected]> |
To: | "Ron Sluiter" <[email protected]> |
Cc: | tech-talk <[email protected]> |
Date: | Fri, 30 Mar 2012 22:35:35 +0800 |
Hi Ron,
The problem has been solved, I set the wrong base
address to the 2nd board.
Thanks a lot.
2012-03-30
孙纪磊 敬启
中国科学院高能物理研究所1号厅201室 北京市918信箱
100049
Sun Jilei Institute of
High Energy Physics, Chinese Academy of Sciences,
Accelerator Center, Room 201, Hall 1, 19B Yuquan Lu, Shijingshan District, Beijing 100049, People's Republic of China Tel.: (+86)-(0)10-88236287 Email: [email protected] 发件人: Ron Sluiter
发送时间: 2012-03-30 22:26:30
收件人: sunjl
抄送: tech-talk
主题: Re: Problems in using VX2
motor controller
Hello Jilei,
You can confirm that the devOMS driver found the 1st Vx2-002 board and not the 2nd by entering the, dbior "drvOMS" command at the IOC console. The response to the above command should also confirm that the 2nd board should be at 0xFC10. Ron On 3/29/2012 8:43 PM, sunjl wrote:
|