EPICS Home

Experimental Physics and Industrial Control System


 
1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  <20122013  2014  2015  2016  2017  2018  2019  2020  Index 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  <20122013  2014  2015  2016  2017  2018  2019  2020 
<== Date ==> <== Thread ==>

Subject: sequencer & button click
From: Martin Konrad <konrad@ikp.tu-darmstadt.de>
To: tech-talk@aps.anl.gov
Date: Fri, 20 Jul 2012 15:43:53 +0200
Hi,
what's the recommended way to switch from one sequencer state to another
if a button is clicked on the OPI? What type of record do you use for
this? What does the "when" statement look like?

Thanks in advance

Martin

P.S.: When coupling a button with some piece of hardware I usually use
some sort of record that is scanned if the button is clicked. This
results in a message to my device. This obviously does not work with the
sequencer because the value of the record does not change and thus a
monitor would not fire...

-- 
Dipl. Phys. Martin Konrad
Technische Universität Darmstadt
Institut für Kernphysik
Schlossgartenstr. 9
64289 Darmstadt
Tel.: +49-6151-16-5121
Fax: +49-6151-16-4321

Replies:
Re: sequencer & button click Benjamin Franksen
Re: sequencer & button click Andrew Johnson
Re: sequencer & button click Wesley Moore

Navigate by Date:
Prev: Re: Clarification required in SNL Benjamin Franksen
Next: Re: sequencer & button click Benjamin Franksen
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  <20122013  2014  2015  2016  2017  2018  2019  2020 
Navigate by Thread:
Prev: NOBUGS 2012 -- Final Call For Abstracts Tobias.Richter
Next: Re: sequencer & button click Benjamin Franksen
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  <20122013  2014  2015  2016  2017  2018  2019  2020