1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 <2013> 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 | Index | 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 <2013> 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 |
<== Date ==> | <== Thread ==> |
---|
Subject: | SEQ keep PV value during seq-init |
From: | "Fabian S." <[email protected]> |
To: | epics techtalk <[email protected]> |
Date: | Wed, 12 Jun 2013 19:21:11 +0200 |
in my little sequencer program I defined double RUN; assign RUN to "{DEVICE}:ENA_CMD"; monitor RUN; were "{DEVICE}:ENA_CMD"; is a bo record which is set to "1" and kept that way even if the iocapp restarts with autosave but during the iocstartup after the iocinit all is fine (bo still enabled ("1")) 'til the sequencer routine starts then it goes to disabled "0". Is there any chance to keep the PV values as it was during the seq-init? thanks for the help