RE: Motor field "UEIP" cause

[<austen.rose@diamond.ac.uk>]

All,

 

With reference to the MAXv card #Disabled message, I was in contact with Prodex a little while ago, and they introduced a bug in single axis mode thus:

 

I can confirm that in your FW1.42 the #WS does not work in single axis mode. It still works in AA/AM mode.

This was unintentional and we will provide a fix shortly.

 

It was fixed in 1.43.

 

Regards,

 

 

Austen Rose

Senior Software Engineer

+44 (0)1235 77(8495)

 

Diamond Light Source Ltd

Diamond House

Harwell Science and Innovation Campus

Didcot

Oxfordshire OX11 0DE

United Kingdom

 

 

From: tech-talk-bounces@aps.anl.gov [mailto:tech-talk-bounces@aps.anl.gov] On Behalf Of Ron Sluiter
Sent: 03 September 2013 16:42
To: 汪启胜
Cc: tech-talk@aps.anl.gov
Subject: Re: Motor field "UEIP" cause

 

Hello Qisheng,

With regard to the "***MAXv card #Disabled*** Watchdog Timeout CTR =" error message,
I posted this message to tech-talk describing the problem.

What is the serial # of your MAXv board?

Ron


On 8/31/2013 4:02 AM, 汪启胜 wrote:

Dear all,

 

I have a similar behavior as the thread http://www.aps.anl.gov/epics/tech-talk/2010/msg00906.php which posted at 2010. But it occurs when I change the field UEIP anytime. At first, I wrote the UEIP in the motor template, the message “drvMAXv.cc:motorIsr: command error ? card 00” will cause the ioc initialize failed. After remove the field in the db field, the ioc can be loaded successfully and running without problem. But I have encoder, so when I set UEIP to Yes or No, the message come out in console, while the ioc do not crash, and the encoder works also.

 

By the way, I also saw the timing problem when ioc boot, I got the message like "***MAXv card #Disabled*** Watchdog Timeout CTR ="

 

The controller is a mvme5500 running with vxworks, Tornado 2.6. The version of motor is 6-7-1. Any suggestion to remove these messages is appreciated.

 

Best Regards,

Qisheng

 

 

 

-- 

This e-mail and any attachments may contain confidential, copyright and or privileged material, and are for the use of the intended addressee only. If you are not the intended addressee or an authorised recipient of the addressee please notify us of receipt by returning the e-mail and do not use, copy, retain, distribute or disclose the information in or attached to the e-mail.
Any opinions expressed within this e-mail are those of the individual and not necessarily of Diamond Light Source Ltd.
Diamond Light Source Ltd. cannot guarantee that this e-mail or any attachments are free from viruses and we cannot accept liability for any damage which you may sustain as a result of software viruses which may be transmitted in or with the message.
Diamond Light Source Limited (company no. 4375679). Registered in England and Wales with its registered office at Diamond House, Harwell Science and Innovation Campus, Didcot, Oxfordshire, OX11 0DE, United Kingdom