EPICS Home

Experimental Physics and Industrial Control System


 
1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  <20142015  2016  2017  2018  2019  2020  2021  2022  2023  2024  Index 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  <20142015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
<== Date ==> <== Thread ==>

Subject: Usage of the dbNameToAddr funciton
From: ZHANG Zhaohong <[email protected]>
To: <[email protected]>
Date: Thu, 16 Oct 2014 14:44:04 +0800

Hi,

 

I used the dbNameToAddr function in the exampleHello.c file, the buiding was all ok. But,  when executing the “hello” command in the iocsh shell, segment fault will happen. I am wondering about this!

 

 

Kind regards.

 

ZHANG Zhaohong

Beamline Control Group

ZhangHeng Road 239, Pudong district, 201204

SSRF, Shanghai, China

 


Navigate by Date:
Prev: Re: AsynPortDriver setting DRVH of ao? Florian Feldbauer
Next: StreamDevice "in" command disturbed by out command haquin
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  <20142015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
Navigate by Thread:
Prev: Re: Support for hivolt power supply Jörn Wüstenfeld
Next: Re: Usage of the dbNameToAddr funciton ZHANG Zhaohong
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  <20142015  2016  2017  2018  2019  2020  2021  2022  2023  2024