1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 <2014> 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 | Index | 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 <2014> 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 |
<== Date ==> | <== Thread ==> |
---|
Subject: | Re: galil softIOC lose the galil controller |
From: | Mi Qingru <[email protected]> |
To: | Mark Clift <[email protected]>, <[email protected]> |
Date: | Mon, 3 Nov 2014 15:51:51 +0800 |
Hi Mark,
Thanks for your suggestion!
I checked the linux with “route –n” command, and
the IP address of the galil was in it.
I changed the unmanaged switch with a managed switch,
and the galil softIOC ran a long time without any errors.
Qingru
Mi
From: Mark Clift
Sent: Thursday, October 30, 2014 8:17 AM
Subject: galil softIOC lose the galil controller Hi
Qingru, I would guess that the multi-cast route is missing, which is required for the Galil driver you're using. We add the following line into /etc/rc.local route add -net 224.0.0.0 netmask 240.0.0.0 dev eth0 The error simply says it could not poll the first 8 digital inputs with Galil TI (Tell input) command. Also there is a newer Galil driver designed to replace the one your using located here: http://motorapp.github.io/Galil-3-0/ Best wishes, Mark Dr. Mark Clift
Senior Controls Engineer
Australian Synchrotron
800 Blackburn Road
Clayton 3168
Ph: +613 8540 4264
Fax: +613 8540 4200
Mail: [email protected] |