Experimental Physics and Industrial Control System
Hi all,
I ran into another problem.
Using the sequencer (2.2.4) for a state machine was working well. With
the upgrade to EPICS 3.16.1,
some states seem to be skipped. Normally, it would go like READY ->
STARTING -> RUNNING.
I added log messages to verify these states. This is fine.
But using camonitor only show READY -> RUNNING.
The same happens for external software, which uses a channel subscription.
This problem also happens in EPICS7.
Any idea, how I can solve this without implementing some delay workaround.
Cheers,
Simon
--
Simon Reiter
II. Physikalisches Institut
Justus-Liebig-Universtität
Heinrich-Buff-Ring 16
D-35392 Giessen
Tel: +49 641 99 33250
- Replies:
- Re: Sequencer seem to skip states with EPICS 3.16.1 Ralph Lange
- Re: Sequencer seem to skip states with EPICS 3.16.1 Simon Reiter
- Navigate by Date:
- Prev:
Re: Scanning on event number fails with EPICS 3.16 Simon Reiter
- Next:
Re: CAJ and JCA links on website point to SourceForge Andrew Johnson
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
<2018>
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Re: Scanning on event number fails with EPICS 3.16 Ralph Lange
- Next:
Re: Sequencer seem to skip states with EPICS 3.16.1 Ralph Lange
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
<2018>
2019
2020
2021
2022
2023
2024