Marty,
If you're able to tar up what you have, that would be really useful. I'll be able to unpick the bits I need and then feedback our contributions to you and the EPICS community, if that works for you.
Mauro - do you have any comments or suggestions?
Regards,
Ian
-----Original Message-----
From: [email protected] <[email protected]> On Behalf Of Martin L. Smith
Sent: 10 April 2018 11:49
To: [email protected]
Subject: Re: driver support for Gamma Vacuum QPC 4
At APS I have one QPCe running in production now and the EPICS driver mostly works ... at least I have readbacks. There are very few issues that I have not had the time to work on or test just yet.
All readbacks work but I have not been able to test the setpoint readback and settings yet or the high voltage on/off. It has been difficult for me to get my hands on one of these and even more difficult to get a ion pump connected to a test unit for reasons out of my control.
I was going to have it included in the synApps vacApp so that the driver would work with all other ion pumps as well. I would be happy to send the code to anyone that would like to try it out.
Marty
On 04/10/2018 05:01 AM, Jack wrote:
Does anyone use Gamma Vacuum QPC 4 vacuum pump controller ?
Thank you
--
Mauro Giacchini
--
Mauro Giacchini
Control System Specialist ISTITUTO NAZIONALE DI FISICA NUCLEARE
p/f: 0039.049.80.68.558 a: Viale universita' 2, 35020 Legnaro, PD
-ITALY-
e: [email protected] <mailto:[email protected]> s:
yakman000
--------------------------------------------------------------------------------
Avast logo <https://www.avast.com/antivirus>
Questa e-mail è stata controllata per individuare virus con Avast antivirus.
www.avast.com <https://www.avast.com/antivirus>
<#DAB4FAD8-2DD7-40BB-A1B8-4E2AA1F9FDF2>