Experimental Physics and Industrial Control System

Hello,

I'm running a test setup for the QEgui tools as a possible replacement for
the EPICS striptool. The strip chart runs perfectly except for one issue.

The data cuts off after a certain amount of time depending on the number
of channels I am plotting. This is only live data haven't tried the
archive look up yet. So for one channel I get about three days of
plotting. For nine channels I get about one and a half hours. I assume
this has to do with a buffer setting somewhere but after days of searching
I have not been able to find it.

Any help would be greatly appreciated.

Thank you in advance,
Doug Lormand

Replies:

RE: QEgui strip chart question Andrew C. Starritt

Navigate by Date:

Prev: Re: Error LNK2005 building Diamond's nullhttpd module on Windows Andrew Johnson

Next: Re: Error LNK2005 building Diamond's nullhttpd module on Windows J. Lewis Muir

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  <2018>  2019  2020  2021  2022  2023  2024 

Navigate by Thread:

Prev: RE: Error LNK2005 building Diamond's nullhttpd module on Windows Freddie Akeroyd - UKRI STFC

Next: RE: QEgui strip chart question Andrew C. Starritt

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  <2018>  2019  2020  2021  2022  2023  2024