Experimental Physics and Industrial Control System
Hi Doug,
The number of points store for each live PV data is 40000 points.
This is currently hard coded at that value.
For the next release I can certainly increase this value and/or make
it controllable via an environment variable.
Regards
Andrew C. Starritt | Leader Accelerator and Support Systems | Australian Synchrotron
p: (03) 8540 4164 | f: (03) 8540 4200
[email protected] | www.synchrotron.org.au
800 Blackburn Road, Clayton, Victoria 3168
-----Original Message-----
From: [email protected] [mailto:[email protected]] On Behalf Of [email protected]
Sent: Thursday, 17 May 2018 8:00 AM
To: [email protected]
Subject: QEgui strip chart question
Hello,
I'm running a test setup for the QEgui tools as a possible replacement for
the EPICS striptool. The strip chart runs perfectly except for one issue.
The data cuts off after a certain amount of time depending on the number
of channels I am plotting. This is only live data haven't tried the
archive look up yet. So for one channel I get about three days of
plotting. For nine channels I get about one and a half hours. I assume
this has to do with a buffer setting somewhere but after days of searching
I have not been able to find it.
Any help would be greatly appreciated.
Thank you in advance,
Doug Lormand
- References:
- QEgui strip chart question marc . lormand
- Navigate by Date:
- Prev:
Re: Amptek IOC: Problem with subnet Andrew Johnson
- Next:
EPICS control of an Edwards STP turbomolecular pump Lucock, Richard M
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
<2018>
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
QEgui strip chart question marc . lormand
- Next:
Question regarding asynParamInt32Array Jörn Dreyer
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
<2018>
2019
2020
2021
2022
2023
2024