Experimental Physics and Industrial Control System
Hi Folks,
I'm trying to get a PIXIS camera from Priceton Instruments working with the
ADPIcam driver and PIcamSDK 5.6.1 under Linux. The driver compiles fine (after
some changes to the Makefile). It can see the camera and extract all
information about existing and relevance status of the camera parameters.
Her are my questions:
1) When does the driver set the parameters in the camera? As soon as I change
them, or only on start of acquisition?
2) I observe a strange behavior of the TriggerMode parameter in the ADBase
panel in CSS. According to the database file it should offer two options:
Internal and External. Instead it offers three options for my detector which
fit to the real possibilities of the camera, but TriggerMode and
TriggerMode_RBV do not match! Where do these settings get changed?
3) If I change the acquire time of the camera, it looks as this setting does
not have an effect. Probably this refers back to question one, but we tried to
stop and start the acquisition of the camera without any change in readout
speed when changing the acquire time from 1s to 10 seconds.
Can anybody shed some light on these questions?
With kind regards,
Jörn Dreyer
- Replies:
- RE: ADPIcam driver question Mark Rivers via Tech-talk
- Navigate by Date:
- Prev:
Re: generalTime/epicsTimeGetCurrent and casr questions William Layne via Tech-talk
- Next:
Re: I'm looking for a pvacces example to read PVStructure Marty Kraimer via Tech-talk
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
<2019>
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Re: I'm looking for a pvacces example to read PVStructure Heinz Junkes via Tech-talk
- Next:
RE: ADPIcam driver question Mark Rivers via Tech-talk
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
<2019>
2020
2021
2022
2023
2024