1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 <2019> 2020 2021 2022 2023 2024 | Index | 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 <2019> 2020 2021 2022 2023 2024 |
<== Date ==> | <== Thread ==> |
---|
Subject: | autosave - different PV to read and write |
From: | Ryan Pierce via Tech-talk <[email protected]> |
To: | "[email protected]" <[email protected]> |
Date: | Tue, 20 Aug 2019 08:31:00 -0500 |
Example: The Canberra ISC amplifier can be placed into a mode where it automatically determines the Pole Zero value based on the input signal. This can be done once, and the measured value can continue to be used (assuming the detector or shaping time aren't changed.) If the IOC restarts, it would be helpful to restore this along with all the other settings. This can be read from $(P)$(AMP)PZRBV but it must be set in $(P)$(AMP)PZ
I'm guessing the concept of one PV to write with a separate readback PV is common. Has this been addressed, or is there a need for this?
Regards, Ryan