Probelm with ethernet interface of Galil controller

[wangqisheng--- via Tech-talk <tech-talk@aps.anl.gov>]

Hello, Tech-Talkers

Galil 21X3 card works fine for many years for our beamline BL17U at Shanghai Synchrotron Radiation Facility. Recently there is a Galil DMC-4060 card used to control a six dimensional table. The driver is 3.0 download from githube. The enviornment list as bellow:

dmc 40600 rev 1.3a 22803

epics 3.15

motor 7.1

centos8

The IOC can be initialized and works fine with the serial interface. If ethernet interface is used, the ioc can be started, the small motor edm works, but it will give out "internal error" when the full edm or medm GUI is opened. 

Closing some port number is not helpful. 

Any suggestions are very welcome.

Thanks and Best Regards,

---

Qisheng Wang 汪启胜

Shanghai Synchrotron Radiation Facility
Shanghai Institute of Applied Physics
Chinese Academy of Sciences
239 Zhangheng Road, Pudong District
Shanghai 201204,P.R.China
Tel: +86-21-33933192; Fax: +86-21-33933021
Email: wangqisheng@sinap.ac.cn