Dear All,
I installed the following softwares on the Windows_7_x64 system:
* Microsoft Visual Studio Community 2019
* Strawberry-perl-5.30.1.1
* EPICS base-7.0.3.1
* Hummingbird Exceed v13
* EPICSWindowsTools1.44-x64.msi
====================================
The problem is:
I can run IOC and edit MEDM normally.
But, when I execute a MEDM, the MEDM responds to the button events very slowly, although displaying PVs normally.
When I switch to edit mode, the MEDM disconnects with IOCs and is stuck .
At this time, I can new a MEDM and edit it normally. But when I switch it to execute mode, the same problem would happen immediately.
====================================
Have others seen similar problems? What could be wrong?
Thanks,
Yang
