Re: asyn connetion to wti

[Eric Norum via Tech-talk <tech-talk at aps.anl.gov>]

If you’re attempting to use asynSetOption to set the serial line parameters (bits, parity, etc.) then you need to have a terminal server that accepts RFC2217 commands.  Can you configure your terminal server to do this?

On Nov 20, 2020, at 4:09 PM, Hawi Stecher via Tech-talk <tech-talk at aps.anl.gov> wrote:

Setting is as follows:

drvAsynIPPortConfigure("LS325_IP", "10.1.2.60:2302")

Tried COM:

drvAsynIPPortConfigure("LS325_IP", "10.1.2.60:2302 COM")
INFO -- asynInterposeCOM options extending and perhaps overriding those of lower interface.
WARNING -- Can't set serial port parameters: Device says DON'T 0x2c.
asynSetOption("LS325_IP", 0, "bits", "7")
setOption failed 10.1.2.60:2302 COM timeout: Resource temporarily unavailable
asynSetOption("LS325_IP", 0, "parity", "odd")
setOption failed 10.1.2.60:2302 COM timeout: Resource temporarily unavailable

-- 
Eric Norum
wenorum at lbl.gov