Hello,
I am using epics R3.15.5 and most builds are not correct. In fact, the
compilation is always successful but a lot of process variables (usually
binary PVs) do not have their readback available and I get these errors
when I run the IOC:
*Starting iocInit
############################################################################
## EPICS R3.15.5
## EPICS Base built Jun 24 2021
############################################################################
2021/06/30 09:14:18.936 asynPortDriver:drvUserCreate: addr=0, cannot
find parameter ucav_min_sw
SL-SCL-CM1:LRF-EC-1:UCavMinRd devAsynInt32::initCommon drvUserCreate
2021/06/30 09:14:18.936 asynPortDriver:drvUserCreate: addr=0, cannot
find parameter uci_min_sw
SL-SCL-CM1:LRF-EC-1:UCiMinRd devAsynInt32::initCommon drvUserCreate
2021/06/30 09:14:18.936 asynPortDriver:drvUserCreate: addr=0, cannot
find parameter dump_meas_delay
SL-SCL-CM1:LRF-EC-1:DumpMeasDelayRd devAsynInt32::initCommon drvUserCreate
2021/06/30 09:14:18.936 asynPortDriver:drvUserCreate: addr=0, cannot
find parameter pm_sp_rate
SL-SCL-CM1:LRF-EC-1:PmSpRateRd devAsynInt32::initCommon drvUserCreate
2021/06/30 09:14:18.937 asynPortDriver:drvUserCreate: addr=0, cannot
find parameter pm_meas_delay
SL-SCL-CM1:LRF-EC-1:PmMeasDelayRd devAsynInt32::initCommon drvUserCreate
2021/06/30 09:14:18.937 asynPortDriver:drvUserCreate: addr=0, cannot
find parameter samp_dur
SL-SCL-CM1:LRF-EC-1:PmSpDurRd devAsynInt32::initCommon drvUserCreate
2021/06/30 09:14:18.937 asynPortDriver:drvUserCreate: addr=0, cannot
find parameter ff_gain_i
SL-SCL-CM1:LRF-EC-1:FfGainIRd devAsynFloat64::initCommon drvUserCreate
2021/06/30 09:14:18.938 asynPortDriver:drvUserCreate: addr=0, cannot
find parameter ff_gain_q
SL-SCL-CM1:LRF-EC-1:FfGainQRd devAsynFloat64::initCommon drvUserCreate *
Has anyone gotten these same errors?
Thanks in advance, Adrián.
--
*Adrián Martínez*
Embedded Software Engineer
Seven Solutions
Mail: adrian.martinez at sevensols.com <mailto:adrian.martinez at sevensols.com>
www.sevensols.com <http://www.sevensols.com/>
This e-mail and any materials attached hereto, including, without
limitation, all content hereof and thereof are confidential and
proprietary to Seven Solutions,S.L and/or its affiliates, and are
*confidential*. Without the prior written consent of Seven Solutions,
this content may not (i) be disclosed to any third party, (ii) be
reproduced, modified or otherwise used by anyone other than current
employees of Seven Solutions or its affiliates. If you are not the
intended recipient or if this message has been received in error, please
notify us immediately via e-mail and delete it.