1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 <2021> 2022 2023 2024 | Index | 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 <2021> 2022 2023 2024 |
<== Date ==> | <== Thread ==> |
---|
Subject: | nPoint motor driver |
From: | Randall Cayford via Tech-talk <tech-talk at aps.anl.gov> |
To: | "Engbretson, Mark S. via Tech-talk" <tech-talk at aps.anl.gov> |
Date: | Fri, 5 Nov 2021 10:52:20 -0700 |
I’m trying to set up an nPoint LC402 motor controller and I can’t figure out how to load the motor positions. There is a driver in the synApps motor modules and the documentation talks a lot about controlling the stepping through the wavetable but I can’t figure out what PVs I’m supposed to use to set the wavetable values. Does anyone know how to upload the wavetable to an nPoint controller? Randall