Re: [EXTERNAL] CSS Toggle button advice

[Donny Domagoj Cosic via Tech-talk <tech-talk at aps.anl.gov>]

Hi Kay,

Thank you very much for your advice. It worked like a charm!

Regards,
---
Donny Domagoj Cosic

Laboratory for Ion Beam Interactions
Ruđer Bošković Institute
Bijenička cesta 54 | HR-10 000 Zagreb | CROATIA
T: +385 1 4561 041 | @: dcosic at irb.hr | www.irb.hr

Dana 13.12.2021 15:08, Kasemir, Kay je napisao(la):
> The toggle button interfaces to a boolean PV, which is basically an
> enum PV with two states.
>
>  Create an mbbo record on the IOC, either add it to your existing IOC,
> or to a new soft IOC, which has two states and uses 000000 for the
> zero value, 111111 for the one value.
>
>  -Kay
>
> -------------------------
>
> FROM: Tech-talk <tech-talk-bounces at aps.anl.gov> on behalf of Donny
> Domagoj Cosic via Tech-talk <tech-talk at aps.anl.gov>
>  SENT: Monday, December 13, 2021 9:03 AM
>  TO: Tech-talk <tech-talk at aps.anl.gov>
>  SUBJECT: [EXTERNAL] CSS Toggle button advice
>
> Hello,
>
>  I would like to create a toggle button that sends 111111 when pressed
>
>  and 000000 when depressed to a PV that in turned sends a command to a
>
>  device using StreamDevice. I am not sure how to do this because the
> only
>  toggle type widget available in CSS is a boolean button which can
> send 1
>  or 0. Could I do this using a padding in the device proto file, but
> how
>  to make the padding depended on the input?
>  Any advice how this can be achieved would be greatly appreciated.
>
>  Regards,
>  --
>  Donny Domagoj Cosic
>
>  Laboratory for Ion Beam Interactions
>  Ruđer Bošković Institute
>  Bijenička cesta 54 | HR-10 000 Zagreb | CROATIA
>  T: +385 1 4561 041 | @: dcosic at irb.hr | www.irb.hr