| 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 <2023> 2024 2025 | Index | 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 <2023> 2024 2025 |
| <== Date ==> | <== Thread ==> |
|---|
| Subject: | ADEiger Monitor |
| From: | John Dobbins via Tech-talk <tech-talk at aps.anl.gov> |
| To: | "tech-talk at aps.anl.gov" <tech-talk at aps.anl.gov> |
| Date: | Thu, 18 May 2023 01:22:41 +0000 |
|
All,
I tried Monitor mode on an EIGER for the first time and was a little surprised by one aspect. I set MonitorEnable = Enable. I see that ImageJ images immediately starts updating at ~ 8 Hz. I believe it is repeatedly
receiving the same image. If I then trigger the EIGER, the images displayed in ImageJ change from image to image.
It is the first part that surprised me, i.e. that ImageJ reports a non-zero Frames/s even when the EIGER is not acquiring images. Is this normal?
EIGER 2X
firmware version release-2020.2.6
SDK Version 1.8.0
Driver Version 3.4.0
ADCore Version 3.12.1
Thanks,
John Dobbins
Research Support Specialist
Cornell High Energy Synchrotron
Source
Cornell University
|