Experimental Physics and Industrial Control System
Dear all,
after updating from EPICS 3.14.12.6 to 3.16.1 I receive the following
message.
A PV is set by the sequencer (2.2.4). It is actually done, but every
time, the sequencer set the PV, I get this message.
sevr=minor ca_array_put(typeToCA(type), count, var->chid, value):
Channel write request failed
int pv_variable;
assign pv_variable to "{IOC}:timeout:S";
pv_variable = value;
pvPut(pv_variable);
The connected PV is binary output.
Best regards,
Simon
--
Simon Reiter
II. Physikalisches Institut
Justus-Liebig-Universtität
Heinrich-Buff-Ring 16
D-35392 Giessen
Tel: +49 641 99 33250
- Replies:
- Re: pvPut error message by Sequencer Benjamin Franksen
- References:
- Scanning on event number fails with EPICS 3.16 Simon Reiter
- Navigate by Date:
- Prev:
Scanning on event number fails with EPICS 3.16 Simon Reiter
- Next:
Re: Scanning on event number fails with EPICS 3.16 Benjamin Franksen
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
<2018>
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Scanning on event number fails with EPICS 3.16 Simon Reiter
- Next:
Re: pvPut error message by Sequencer Benjamin Franksen
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
<2018>
2019
2020
2021
2022
2023
2024