-----Original Message-----
From: [email protected] <[email protected]> On
Behalf Of Dirk Zimoch
Sent: Wednesday, April 25, 2018 10:19 AM
To: [email protected]
Subject: Re: using epics-base with yocto
Hello Mariano,
I compile EPICS with Yocto 2.1 / Petalinux toolchain for the XILINX Zynq
Ultrascale.
My config file is attached. But it needs 3 additional macros:
GNU_HOST_ARCH=i686
GNU_HOST_OS=linux
are defined in my CONFIG_SITE.linux-x86.Common
GNU_HOST_ARCH_64=x86_64
is defined in my CONFIG_SITE.linux-x86_64.Common
(I use them in several embedded Linux cross compiler configs and did not
want to pull too many host specifics into a CONFIG.Common.* file.)
Also be aware that you have probably installed yocto somewhere else. Fix
SDK_DIR accordingly.
I could use this cross compiler only on a 64 bit host, but that should not
be much of a problem nowadays.
Best regards,
Dirk
On 24.04.2018 15:45, Mariano Ruiz wrote:
Dear tech-talkers,
I am trying to create a Linux embedded distribution using Yocto
including epics-base.
Does anyone have a yocto meta-layer already implemented?
Thanks a lot
Mariano Ruiz
Professor
Technical University of Madrid
<https://www.avast.com/sig-email?utm_medium=email&utm_source=link&utm_campai
gn=sig-email&utm_content=emailclient&utm_term=icon>
Virus-free. www.avast.com
<https://www.avast.com/sig-email?utm_medium=email&utm_source=link&utm_
campaign=sig-email&utm_content=emailclient&utm_term=link>
<#DAB4FAD8-2DD7-40BB-A1B8-4E2AA1F9FDF2>
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus