| 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 <2022> 2023 2024 2025 | Index | 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 <2022> 2023 2024 2025 |
| <== Date ==> | <== Thread ==> |
|---|
| Subject: | RE: Removing battery/crystal from MVME 5100 |
| From: | "Stone, Eric D via Tech-talk" <tech-talk at aps.anl.gov> |
| To: | "Walsh, Thomas R." <twalsh at anl.gov>, "tech-talk at aps.anl.gov" <tech-talk at aps.anl.gov> |
| Date: | Thu, 9 Jun 2022 19:09:11 +0000 |
|
Tom – appreciate the response, thank you very much. Thank you, Eric D. Stone K1 Technical Director Lockheed Martin RMS Desk: (856) 608-6619 Cell: (856) 242-4051 SIPR: (Include “Attn: Eric Stone” in the subject line) nscc at lmnj.contractor.techrep.navy.smil.mil From: Walsh, Thomas R. <twalsh at anl.gov> Hi Eric, I have nothing in writing, but I can tell you how I change the crystals out. I put the card on an ESD mat and then using a scribe(or small standard jeweler screwdriver) I begin
lifting the corner marked with the dot . Once I feel it move a little I go to the diagonal corner and lift up. Once this corner starts to come up, the crystal is loose enough to remove with my fingers. Go slow and watch not to scratch the conformal coating
of the PCB. Tom Walsh 630-252-5621 |