Experimental Physics and Industrial Control System
Hi,
Could someone give me an explanation on how to use the RARM and BUSY
fields in the waveform record? Why do we need a BUSY field if we already
have PACT? I'm writing a device support routine to read a serial port
using the waveform record and I'm not sure how to use these fields. I
found that about half of the device support routines in the EPICS
distribution doesn't use them at all. The documentation doesn't say much
either.
Thank you,
Pedro.
- Navigate by Date:
- Prev:
RE: ca_test bus error on solaris-sparc-gnu + fix Jeff Hill
- Next:
Re: ca_test bus error on solaris-sparc-gnu + fix Till Straumann
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
<2002>
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Re: AO Record: New Drive Limit Mode? Ralph . Lange
- Next:
Re: waveform record question Pedro Gigoux
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
<2002>
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024