1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 <2007> 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 | Index | 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 <2007> 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 |
<== Date ==> | <== Thread ==> |
---|
Subject: | Re: waveform binary init |
From: | Dirk Zimoch <[email protected]> |
To: | Heinrich du Toit <[email protected]> |
Cc: | TechTalk EPICS <[email protected]> |
Date: | Mon, 02 Jul 2007 09:50:37 +0200 |
Hi
I have an octet device. (asyn driver) It sends commands to some hardware. Now if I send a certain sequence of chars to the device I can perform some stuff. e.g. reset the device. Or set a certain mode. - things that will correspond to buttons on the user interface.
So I like to setup a waveform record with the necessary data inside as default. And then only trigger the PROC field so that the data be written to the device.
My only question is - how do I specify this binary data to the waveform? for example how do I setup a waveform with CHAR data: 00 01 08 or something like that?
does the waveform things also read once at start up with asyn? even if it is a write only command?
thanks -Heinrich
-- Dr. Dirk Zimoch Computing and Controls Paul Scherrer Institut phone +41 56 310 5182 fax +41 56 310 4413
Attachment:
array.tgz
Description: application/compressed-tar