| 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 <2008> 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 2025 | Index | 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 <2008> 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 2025 |
| <== Date ==> | <== Thread ==> |
|---|
| Subject: | Problems with Base 3.14.10. and Sequencer 2.0.12 on Cygwin? |
| From: | "Steve Banks" <[email protected]> |
| To: | <[email protected]> |
| Date: | Sun, 7 Dec 2008 15:37:12 +1100 |
|
Hi all, Has anyone else run into problems with the example app in EPICS
Base 3.14.10 with Sequencer 2.0.12 when running on Cygwin (ARCH=cygwin-x86)? When I build the example application with the SNCSEQ in the
RELEASE file commented out, the IOC builds fine and my trusty old EPICS console
starts up with no problem. When I rebuild the application with
SNCSEQ=/epics/seq in the RELEASE file, it builds fine but when I run the IOC it
goes immediately back to the bash command prompt, no errors, no EPICS console. It’s been a couple of years since I last built an
EPICS app so I’m a bit rusty at this stuff… if anyone can give me a
hand it would be greatly appreciated. Best regards, Steve Banks |