EPICS Home

Experimental Physics and Industrial Control System


 
1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  <2009>  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024  2025  Index 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  <2009>  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024  2025 
<== Date ==> <== Thread ==>
Subject: Re: EDM GUI disable/enable
From: Ralph Lange <[email protected]>
To: Steve Kinder <[email protected]>
Cc: EPICS Tech Talk <[email protected]>
Date: Fri, 11 Dec 2009 10:12:03 -0500
Can't you put a nearly full size rectangle saying "Device resetting - please wait." in front of the other controls of the panel, and make it visible only in one state of your binary record? 

Ralph


On Fri 11 Dec 2009 5:16:07 Steve Kinder wrote:
I would like to be able to disable/enable an entire EDM GUI in a manner similar to what happens when an IOC goes away and is restarted. So say a device reset is initiated and you want to disable a GUI whilst that is happening. This could be based on the state of a binary record. Would anyone have a suggestion as to how this might be done please. Regards Steve
References:
EDM GUI disable/enable Steve Kinder
Navigate by Date:
Prev: Rethinking asyn motor drivers Mark Rivers
Next: Re: Reading an array of strings from a Waveform record Andrew Johnson
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  <2009>  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024  2025 
Navigate by Thread:
Prev: RE: EDM GUI disable/enable tom.cobb
Next: Planned changes to ASYN drvAsynIPPort Eric Norum
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  <2009>  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024  2025