Re: Building seq-2.0.11 with base-3.14.12

[<jun-ichi.odagiri@kek.jp>]

Hi, Andrew and all;

> The latest non-experimental released version of the sequencer is 2.0.
12, which 
> does build with 3.14.12.

It's just that I wasn't aware of it. I've tried sncseq-2.0.12 with
base-3.14.12. I've built it without any problems. I'd like to thank
all of you who kindly let me know with rapid responses. 

Thank you very much!

Jun-ichi


----- Original Message -----
> Hi,
> 
> On Tuesday 11 January 2011 23:56:33 jun-ichi.odagiri@kek.jp wrote:
> >
> > I tried to build seq-2.0.11 with base-3.14.12 on CentOS 5.5 to
> > find that it fails. (I attatch the log messages below this writing.)
> > It looks like the problem is something under base/configure though
> > I'm not sure on this point.
> 
> The latest non-experimental released version of the sequencer is 2.0.
12, which 
> does build with 3.14.12.
> 
> If you prefer to modify your 2.0.11 installation though, you will need 
to 
> remove all mention of the iocsh library from the src/seq/Makefile — it 
was 
> merged into libCom in Base 3.14.10.  Under src/snc/Makefile you should 
also 
> remove the lines setting SYS_PROD_LIBS_Linux and SYS_PROD_LIBS_DEFAULT.
  There 
> were some other changes between 2.0.11 and 2.0.12, but I'm not sure if 
they're 
> essential; it will probably be quicker to just download 2.0.12.
> 
> - Andrew
> -- 
> If a man is offered a fact which goes against his instincts, he will
> scrutinize it closely, and unless the evidence is overwhelming, he 
will
> refuse to believe it.  If, on the other hand, he is offered something
> which affords a reason for acting in accordance to his instincts, he
> will accept it even on the slightest evidence.  -- Bertrand Russell
> 
>