Experimental Physics and Industrial Control System
Hello,
I have a waveform.
I would like to apply a linear transformation to that waveform.
The simplest case would be
* calibration of ADC raw values to voltages
* transformation from voltage to engineering units
Is there a simple way to do this?
Ultimately I would like to use a subArray....
So far the only way I have found to do the above is to this is by transforming the waveform in the C code.
Is it possible to do the same in the IOC database?
--
Emmanuel
- Replies:
- Re: waveform transformation Tim Mooney
- Navigate by Date:
- Prev:
RE: epicsqt first try Andrew Rhyder
- Next:
non-normalized X WaveF / Y WaveF display emmanuel_mayssat
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
<2011>
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
RE: Breakpoint Table Error Steiner, Mathias
- Next:
Re: waveform transformation Tim Mooney
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
<2011>
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024