Hi all,
First, I am very new to Epics, so if I ask real basic questions, I am very sorry but I am trying to search alot before I ask.
I installed Labview one side on Windows 7. On the other side, epics 3.15 was installed on Linux Opensuse. No problem happened.
I want to connect two part using 1 router. Two has
ethernet port.
I build an example using Labview. You can see the example in the following link. (http://www.ni.com/white-paper/14149/en)
When I tried to read Amplitude and Frequency value in opensuse using Probe, I couldn't connect and got these values.
I disabled firewall both side and their subnet is the same.
Linux ip : 192.169.1.101
Windows ip: 192.169.1.100
I can reach Linux by putty, there is nothing wrong with the connection I guess. I can ping the Linux ip from the
windows.
Do I need to set the variables ?
export EPICS_CA_ADDR_LIST= windows ip
I tried to read datas by caget but I wasn't in this too.