EPICS Home

Experimental Physics and Industrial Control System


 
1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  <20142015  2016  2017  2018  2019  2020  2021  2022  2023  2024  Index 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  <20142015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
<== Date ==> <== Thread ==>

Subject: Re: Tektronix DMM 4050 device support
From: Hovanes Egiyan <[email protected]>
To: [email protected], [email protected]
Date: Fri, 31 Oct 2014 08:31:01 -0400
Hello Pavel,

I also need to read out a Tektronix DMM 4050 multimeter. Did you find or develop
an EPICS interface for it?

Thanks,
    Hovanes Egiyan.

On 04/02/2013 07:27 AM, Pavel Maslov wrote:
Hi,

Does anyone have EPICS device support for the Tektronix DMM 4050 multimeter?
Thanks in advance.

--
Best regards,


Pavel Maslov, MS
Controls Engineer at Pulsed power Lab
Efremov Institute for Electro-Physical Apparatus
St. Petersburg, Russia

Mobile: +7 (951) 672 22 19
Landline: +7 (812) 461 01 01


Navigate by Date:
Prev: RE: galil softIOC lose the galil controller Mark Clift
Next: RE: galil softIOC lose the galil controller Mark Clift
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  <20142015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
Navigate by Thread:
Prev: Re: Re: read waveform data using ca_create_subscription 吴煊
Next: Hytec 8402 DAC memory mode on a TVME200 IP carrier Ron Sluiter
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  <20142015  2016  2017  2018  2019  2020  2021  2022  2023  2024