1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 <2015> 2016 2017 2018 2019 2020 2021 2022 2023 2024 | Index | 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 <2015> 2016 2017 2018 2019 2020 2021 2022 2023 2024 |
<== Date ==> | <== Thread ==> |
---|
Subject: | Re: Stepper Motor Controllers |
From: | Kevin Peterson <[email protected]> |
To: | Mark Rivers <[email protected]> |
Cc: | "<[email protected]>" <[email protected]>, "[email protected]" <[email protected]> |
Date: | Tue, 21 Jul 2015 17:01:11 -0500 |
Does setting the SmartStageName to an empty string prevent the XPS's "Auto configuration" from auto-detecting which axis is connected to a channel? Do you configure your XPS controllers manually? Kevin On 7/12/15 4:51 PM, Mark Rivers wrote: > Note that I have commented out the line > > ;SmartStageName = UTS100CC > > and replaced it with: > > SmartStageName =