1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 <2016> 2017 2018 2019 2020 2021 2022 2023 2024 | Index | 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 <2016> 2017 2018 2019 2020 2021 2022 2023 2024 |
<== Date ==> | <== Thread ==> |
---|
Subject: | Show alarms, events and measurements from DSP in CS-Studio and generate files with this data |
From: | Carlos Gómez Martinez <[email protected]> |
To: | "[email protected]" <[email protected]> |
Date: | Fri, 11 Mar 2016 10:29:38 +0100 |
Hi , I am Carlos from Spain and I am developing an HMI, it consists of: A DSP sends measurements, alarms and events through modbus addresses, these data are converted to EPICS and displayed on screen with CSS. The "brain" of the project is the DSP, ie, alarms are not made by epics, alarms are generated by the DSP and the cs-studio is only displayed if there is failure, if there is no fault, measures etc .. I would know how these failures can be collected, events and actions and how I can build a table in CS-Studio where these data to be displayed and also to generate a file with this data. Thanks, Carlos |