| 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 <2017> 2018 2019 2020 2021 2022 2023 2024 | Index | 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 <2017> 2018 2019 2020 2021 2022 2023 2024 |
| <== Date ==> | <== Thread ==> |
|---|
| Subject: | Re: How to compile only for a target architecture |
| From: | Ricardo Herrero <[email protected]> |
| To: | Kevin Peterson <[email protected]> |
| Cc: | [email protected] |
| Date: | Wed, 12 Jul 2017 23:39:01 +0200 |
Thanks for your quick reply, Kevin.However what I´m looking for is to compile only for a target_architecture and not for the host. For example Host: x86_64 Target: Linux-arm. I just want to compile for linux-arm from my x86 host.
Regards, Ricardo El 2017-07-12 23:32, Kevin Peterson escribió:
Ricardo, If you leave CROSS_COMPILER_TARGET_ARCHS empty in the configure/CONFIG_SITE of the module you're building, it should only build for the host arch: CROSS_COMPILER_TARGET_ARCHS = Kevin On 07/12/2017 04:24 PM, Ricardo Herrero wrote:Hello, I want to ask you how to compile only for one target architecture inEPICS. In the application developer´s guide it is not clear enough . It seems as it always compile for host and for other target architectures.I want to compile for one target architecture, but not all of them and not for the host architecture. I just need to compile for linux-arm in any case from a x86_64. How can I do that?Thanks for your help, in case you need it I can send you the Makefiles I´m working on. Ricardo
-- Doctorando i2a2 Jefe de Area de Ingeniería de Sistemas - CEH- CEDEX