Ricardo,
If you leave CROSS_COMPILER_TARGET_ARCHS empty in the
configure/CONFIG_SITE of the module you're building, it should only
build for the host arch:
CROSS_COMPILER_TARGET_ARCHS =
Kevin
On 07/12/2017 04:24 PM, Ricardo Herrero wrote:
Hello,
I want to ask you how to compile only for one target architecture in
EPICS. In the application developer´s guide it is not clear enough . It
seems as it always compile for host and for other target architectures.
I want to compile for one target architecture, but not all of them and
not for the host architecture. I just need to compile for linux-arm in
any case from a x86_64. How can I do that?
Thanks for your help, in case you need it I can send you the Makefiles I
´m working on.
Ricardo
- Replies:
- Re: How to compile only for a target architecture Ricardo Herrero
- References:
- How to compile only for a target architecture Ricardo Herrero
- Navigate by Date:
- Prev:
How to compile only for a target architecture Ricardo Herrero
- Next:
Re: How to compile only for a target architecture Ricardo Herrero
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
<2017>
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
How to compile only for a target architecture Ricardo Herrero
- Next:
Re: How to compile only for a target architecture Ricardo Herrero
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
<2017>
2018
2019
2020
2021
2022
2023
2024
|