1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 <2020> 2021 2022 2023 2024 | Index | 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 <2020> 2021 2022 2023 2024 |
<== Date ==> | <== Thread ==> |
---|
Subject: | RE: device support for Newstep NSC200 from Newport |
From: | Mark Rivers via Tech-talk <tech-talk at aps.anl.gov> |
To: | "'Sintschuk, Michael'" <michael.sintschuk at bam.de> |
Cc: | "tech-talk at aps.anl.gov" <tech-talk at aps.anl.gov> |
Date: | Thu, 15 Oct 2020 13:56:17 +0000 |
Hi Michael, I would refer you to this tech-talk thread which is not about the NSC200, but my reply would be the same: https://epics.anl.gov/tech-talk/2020/msg00690.php
The NSC200 appears to have a similar command set to the AG-CONEX. There is an EPICS model 3 motor driver that I wrote for that here: https://github.com/epics-motor/motorNewport/blob/master/newportApp/src/AG_CONEX.cpp
I suspect that you may be able to enhance that driver to also support the NSC200. If it is too different then you could make a new driver based on it. My later conversations with Igor were offline from tech-talk, but I think he just modified that AG-Conex driver to also support the DL325. If so we may be able to merge
his version back into the master branch, and you can see how he did it. Mark From: Tech-talk <tech-talk-bounces at aps.anl.gov> On Behalf Of
Sintschuk, Michael via Tech-talk Hello all, does anyone has an EPICS motor driver for the motion controller “NewStep NSC200” from Newport: https://www.newport.com/medias/sys_master/images/images/he3/h40/8797222567966/NSC200-User-Manual.pdf ? Sharing is greatly appreciated! Best regards Michael Michael Sintschuk
P: +49 30 8104-4065 (BAM, Steglitz) |