Folks,
I am writing to report a possible problem with base 7.0.4 on Windows.
Today I updated EPICS on a Windows machine from base 7.0.3.1 to 7.0.4. This machine runs 3 EPICS IOCs; 2 are areaDetector camera IOCs and the third runs various serial and TCP devices.
The behavior I observed was strange.
- The first 2 IOCs to start worked fine, I could connect to them from Channel Access clients.
- The third IOC started fine, and dbl showed all the PVs. However, I could not connect to them from any Channel Access client (medm ,caget, etc.)
If I changed the order in which I started the IOCs it appears that the last IOC to start is the one that cannot connect with Channel Access.
I rolled back to the 7.0.3.1 versions of the IOCs and they all connect fine.
I cannot say that I have conclusively proved the above by starting the IOCs in all different orders, etc. But it looking like a problem.
Were there any changes in 7.0.4 that might have caused such a problem?
Mark
- Replies:
- Re: Possible problem with base 7.0.4 on Windows Johnson, Andrew N. via Core-talk
- Navigate by Date:
- Prev:
[Bug 1881563] Re: Empty arrays have undefined behavior mdavidsaver via Core-talk
- Next:
Re: Possible problem with base 7.0.4 on Windows Johnson, Andrew N. via Core-talk
- Index:
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
<2020>
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Build failed: EPICS Base 7 base-7.0-31 AppVeyor via Core-talk
- Next:
Re: Possible problem with base 7.0.4 on Windows Johnson, Andrew N. via Core-talk
- Index:
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
<2020>
2021
2022
2023
2024
|