Experimental Physics and
Industrial Control System

[email protected] (John Quintana) · Sat, 24 Jun 1995 12:13:35 -0500 (CDT)

I apologize if this is a trivial question, but I can't seem to find
the answer.  I am trying to bundle up the R3.12.0Beta13 base port
to Linux so other people can hack/use it.  I've tested the port on
my crate with a simple soft analog input record.  Things seem to work
with the exception of the starting of caRepeater.  Before I delve into
the code, I was wondering if this happens on other platforms or
perhaps I am just doing something wrong.

1) startCArepeater does nothing.  This is where I am confused.
   startCArepeater just calls ca_task_initialize which returns
   without doing anything if ca_static is NULL.  I can't seem to
   find where it is initialized since it is defined as
   a pointer.  startCArepeater also doesn't give any error messages.

2) Given the above, the clients don't seem to start caRepeater; however,
   if I start it by hand (e.g.    caRepeater &    ), then ca_test
   can talk to my crate.

I'm sure that I'm just missing something fundamental.

- John

--
John Quintana                          Internet email: [email protected]
DND-CAT Synchrotron Research Center    Voice Phone: (708) 252-0223
APS/ANL Sector 5, Bldg. 400            FAX Phone: (708) 252-0226
9700 South Cass Avenue                 WWW: http://tomato.dnd.aps.anl.gov/~jpq/
Argonne, Illinois 60439

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System