Hi,
Does anybody knows if there is an ADC in the EPICS supported hardware
list which is capable to measure the peak voltage of a transient signal
occuring during a gate ?
This is a typical Data acquisition application that I was able to make
with old CAMAC modules.
I understand that this is probably a very marginal application for
EPICS, but who knows...
Dominique
--
Dominique Boutigny (E-mail: [email protected])
Laboratoire d'Annecy-le-Vieux de Physique des Particules (L.A.P.P.)
Chemin de Bellevue BP 110 F-74941 Annecy le Vieux CEDEX - France
Now at SLAC - PO Box 4349 - Mail Stop 41 - 94309 Stanford CA - USA
Tel@ SLAC: 650 926 3596 Pager : (650) 849 9218
Fax@ SLAC: 650 926 8522 [email protected]
- Navigate by Date:
- Prev:
Re: Calling all Power PC EPICS sites Benjamin Franksen
- Next:
RE: Need an EPICS supported "peak sensing" ADC Mark Rivers
- Index:
1994
1995
1996
1997
1998
<1999>
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Build problems Dave Reid
- Next:
RE: Need an EPICS supported "peak sensing" ADC Mark Rivers
- Index:
1994
1995
1996
1997
1998
<1999>
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|